Procedure for installing and configuring program components

Perform the steps for program installation and configuration in the following sequence:

  1. Install the disk image containing the Sandbox component.
  2. Configure the Sandbox component through the Sandbox web interface.
  3. Install the disk images of Microsoft Windows operating systems and software for the Sandbox component.
  4. Install the disk image containing the Central Node and Sensor components. Configure the Central Node and Sensor components.

    If there are multiple Central Node components, you can use the program in distributed solution mode.

    If there are multiple Sensor components, you can install and configure the Sensor component on the necessary number of servers.

    If you need to use the Central Node component separately from the Sensor component, skip the steps on configuring the Sensor component when installing the Central Node and Sensor components.

  5. Install the Endpoint Sensors component on computers that belong to the corporate IT infrastructure.
Page top