Special considerations for installing the Endpoint Sensors component if the program is used together with KES

Compatibility of KES and Endpoint Sensors component version 3.5

If you are using KES version 10 SP2 MR3 or 11.0 and you want to use the standalone Endpoint Sensors component version 3.5:

Disable the Endpoint Sensors component in the KES program.
For more details on how to disable the Endpoint Sensors component in the KES program, refer to the Kaspersky Endpoint Security Help.
Install the standalone Endpoint Sensors component version 3.5 on all the computers of your organization's local area network on which you want to use the Endpoint Sensors component.

Compatibility of KES with the standalone Endpoint Sensors component version 3.6

The installation scenario for a standalone Endpoint Sensors component version 3.6 and the KES program on the same computer depends on the version of KES. Information on compatibility of the program and component and installation scenarios are presented in the following table.

KES 11.1 is compatible only with the Endpoint Sensors component included with the KES program. You cannot install KES 11.1 and the standalone Endpoint Sensors component on the same computer.

Installation scenarios for KES and the standalone Endpoint Sensors component

Version of KES	Installing the standalone Endpoint Sensors component after installing KES	Installing KES after installing the Endpoint Sensors component
KES10 SP1 MR3 KES10 SP1 MR4 KSC 10 SP2 KSC 10 SP2 MR1 KSC 10 SP2 MR2 KSC 10 SP2 MR3	Standard installation procedure.	Standard installation procedure.
KES 11.0.0 KES 11.0.1	You must disable the Endpoint Sensors component included with the KES program. For more details on how to disable the Endpoint Sensors component in the KES program, refer to the Kaspersky Endpoint Security Help. If the component is not disabled, installation fails with an error.	Standard installation procedure.
KES 11.1	Installation fails with an error.	KES removes the standalone Endpoint Sensors component.

Version of KES

Installing the standalone Endpoint Sensors component after installing KES

Installing KES after installing the Endpoint Sensors component

KES10 SP1 MR3
KES10 SP1 MR4
KSC 10 SP2
KSC 10 SP2 MR1
KSC 10 SP2 MR2
KSC 10 SP2 MR3

Standard installation procedure.

KES 11.0.0
KES 11.0.1

You must disable the Endpoint Sensors component included with the KES program.

For more details on how to disable the Endpoint Sensors component in the KES program, refer to the Kaspersky Endpoint Security Help.

If the component is not disabled, installation fails with an error.

Standard installation procedure.

KES 11.1

Installation fails with an error.

KES removes the standalone Endpoint Sensors component.

Page top