To prepare a device for remote installation in non-interactive mode:
Run the riprep.exe file on the client device from the command line with the requisite set of keys.
Utility command line syntax:
riprep.exe [-silent] [-cfg CONFIG_FILE] [-tl traceLevel]
Descriptions of the keys:
-silent—Starts the utility in the non-interactive mode.
-cfg CONFIG_FILE—Defines the utility configuration, where
CONFIG_FILEis the path to the configuration file (a file with the .ini extension).
-tl traceLevel—Defines the trace level, where
traceLevelis a number from 0 to 5. If no key is specified, the value 0 is used.
You can perform the following tasks by starting the utility in silent mode:
You can specify the parameters for device preparation for remote installation in the configuration file specified in the
-cfg key. To define these parameters, add the following information to the configuration file:
Commonsection, specify the tasks to be performed:
DisableSFS—Disable simple file sharing (0—the task is disabled; 1—the task is enabled).
StartServer—Start the Server service (0—the task is disabled; 1—the task is enabled).
OpenFirewallPorts—Open the necessary ports (0—the task is disabled; 1—the task is enabled).
DisableUAC—Disable User Account Control (0—the task is disabled; 1—the task is enabled).
RebootType—Define behavior if restart of device is required when UAC is disabled. You can use the following values:
UserAccountsection, specify the account name (
user) and its password (
Sample context of the configuration file:
After the utility completes, the following files will be created in the utility start folder: