At this step, select the SVMs that you want to remove.
The table shows the following information about hypervisors and SVMs previously deployed on hypervisors:
You can use buttons in the Name column to:
The Integration Server continues to connect to the hypervisor removed from this list or the virtual infrastructure administration server, and to receive information about the virtual infrastructure required for SVM operation.
You can use the Refresh button above the list to update the list of hypervisors in the table.
You can add to the list those hypervisors from which you want to remove SVMs.
To add hypervisors to the list:
The Virtual infrastructure connection settings window opens.
You can specify an IP address in IPv4 format or a fully qualified domain name (FQDN) as the address of the hypervisor or virtual infrastructure administration server. You can separate the IP addresses or full domain names of hypervisors using either a semicolon or a new line.
You can also specify the port used for connecting to the hypervisor or to the virtual infrastructure administration server in the format <IP address>:<port>.
The number of correctly recognized addresses is shown under the list of addresses.
If you use a domain account to connect to a hypervisor or virtual infrastructure administration server, you can specify the account name in the <domain>\<user name> or <user name>@<domain> format.
The Virtual infrastructure connection settings window closes and the selected hypervisors are added to the list of hypervisors. If a connection could not be established with a hypervisor or virtual infrastructure administration server, information about the connection errors is displayed in the table.
To select the SVMs to remove:
select check boxes to the left of SVM names in the table.
Go to the next step in the wizard.
Page top